Design of Smart Card Chip Reader Based on STM32
Abstract
This paper designs a smart card chip reader based on STM32, and gives a block diagram of the overall design of the system. It introduces the design of the peripheral hardware circuit of the main control chip STM32F103CBT6 and the RF processing chip THM3070, and the format of data communication between each part and flow chart. The communication between the host computer and the reader adopts the USB CCID protocol, which supports the USB full-speed communication rate of 12Mbps, improves the interrupt response, and overcomes the shortcomings of the traditional serial port-based readers with low communication speed and poor interrupt response. At the same time, it realizes data interaction with the PC/SC standard PC application and has better versatility
References
Zhou Xiaoguang, Wang Xiaohua. Principle and application of radio frequency identification (RFID) technology. Beijing: People's Posts and Telecommunications Press; 2006.
Chen Qingsong, Wang Jian. Universal serial bus data transmission. Computer Engineering and Design 2006; 27(11): 2077-2079.
Yang Meigang, Li Xiaowen. SPI interface and its application in data exchange. Communication Technology 2007; 40(11).
Copyright (c) 2020 Journal of Networking and Telecommunications
This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License.
